Vehicle oil spill prevention measures

1. Attention to car diagnostic tool gasket role. Put it aside part in the car (for example, each joining side, the cover, housing cover pad, flat enamel cover) plays a leak-proof seal gasket between the parts. If materials, production quality and the installation does not meet the technical specifications, would not achieve the role of leak-proof seal, even accidents. Such as the oil sump or the valve cover, due to a large contact area and less compaction, thereby causing oil spills. Buy more affordable car cushion

2. Car regulations required all types of fastening nut tightening torque. Too loose pressure is not tight gasket leak; too tight will make the screw holes around the metal bumps or threaded screw slip caused by the oil spill. Sump If you do not tighten the oil drain plug or loose back off, likely to cause the loss of oil, and subsequent engine damage, injury Burnt axle ".

3. Replace the car ECU programmer failed oil seal in a timely manner. Car lot and set parts (such as oil seals, O-rings) due to improper installation, journal and seal edge misalignment, deflection and dumped oil. Some oil seal for too long due to the aging of rubber and lose their elasticity. Found leakage shall be updated.

4. To avoid a one-way valve, the ventilation valve blocked. The resulting tank shell temperature rises, oil and gas fills the entire space, emissions do not go out of the tank shell pressure increases oil consumption increase and replacement cycles. Clogging of the engine ventilation system, an increase of the resistance movement of the piston, the increase in fuel consumption. Due to the pressure difference inside and outside the tank shell, tend to cause the weak seal oil. Need to carry out regular inspections of vehicles, and clear, clean.

5. Properly resolve various types of tubing joints sealed. Car disassembly, easy to slip the wire off the buckle loose union nut often will cause oil leakage. Replace the union nut, grinding method to solve the cone seal nut pressed to solve the sealing.

6. Avoid rid galletto 2 of the oil hub. Wheel hub bearing and cavity too much grease or oil seal assembly is wrong, poor quality and aging failure; wheels brake frequently caused by temperature; axle nut loose will cause the wheels dumped oil. Therefore use the "cavity lubrication (ie amount of lubrication), and clear the vent.