Computer Configuration:
Xtruck 125032 Driver: Microsoft Windows 2000 and XP operating systems
Xtruck Software: Windows xp and windows 7 32-bit and 64-bit and windows CE compliant
(Volvo, Hino, Perkins, Cat, and Nissan software must be installed in XP system. Other software can be used in Win7 32bit system.)
Xtruck USB LINK diesel software list:
- Allison
- Bendix 6.3.8.0
- Detroit Diesel DDDL 7.05
- Detroit Diesel DDCT
- Detroit Diesel Calibration Tool
- Eaton Service Ranger 3.2
- International DLB
- International ICAP, IPTS, NETS, IPC
- International Master Diagnostic
- Meritor and Wabco Diagnostics
- Cummins Insite 7.5
- Hino 2.0.3.
- Caterpillar 2.0.1.0
- Perkins EST 2010B
- V Macks 2.6.12
- V Macks Dealer Pro
- Volvo VCADS 2.35.10
- Toyota Techstream for car
Xtruck software supported language
No cable is needed for vehicle diagnostic using the Xtruck USB Link 125032. The diagnostic base system can access the Xtruck USB link via Bluetooth or USB.
Access via Bluetooth:
After a connection to vehicle, the Xtruck USB link has been set up. The Bluetooth software provides a virtual serial COM port (Bluetooth Serial Port Profile). The Diagnostic Base System uses this COM port to communicate with the Xtruck USB link. After built connection with Bluetooth, the system will ask for a PIN “NEXIQ” (with all letters capitalized) to confirm Bluetooth communication. You need to specify this port when you install the diagnostic application.
Access via USB:
You can also connect the Xtruck USB link to the application PC by using the supplied USB cable. Windows detects the Xtruck USB link through Plug and Play, and automatically installs the drivers copied when you installed the diagnostic application. Setup of the Xtruck USB link is then complete and the device is ready for use by the diagnostic application.
No comments:
Post a Comment