v2.23 kess v2 fw 7.020 ECU programmer

Friday, 30 January 2015

MPPS V16 Remap Audi A3 ECU diagnostic case

MPPS V16 is very easy to use. Here is a quick guide on remapping Audi A3 ECU with the tool. The whole process takes about 8 to 10 minutes. Before we start please note that there is risk in ECU reflashing, be careful in every step in order not to break your ECU.
Tools you will need:
1. A XP laptop or a Windows 7 laptop with XP mode package (because MPPS V16 clone is only compatible with XP system.)
2. MPPS V16 ECU reflasher
Quick guide:
1) Plug MPPS to the OBD port under the dashboard on the Audi A3 vehicle and connect the other end of it to a laptop that has MPPS V16 software.
remap Audi A3 ECU with MPPS V16
2) Start the laptop, the car and then the MPPS V16 application software.
3) Hit "ECU ID (F1)" at the bottom right on the interface.
4) Select the language that you want to use on the upper right side. Here I select English, you can use French if you prefer.
remap Audi A3 ECU with MPPS V16
5) Select the car make and car model. Here I select Audi and then A3.

6) Select the cars ECU type. Here I select "1.8L Bosch ME7.1 K-Line".
remap Audi A3 ECU with MPPS V16
7) Be sure the ignition is on, and then hit "Read (F2)" to allow MPPS reading ECU information from the car. Once the data is read, it will pop up in “ECU Data” area.
8) A window will then pops up asking you where to save the file. Do as it prompts.
9) MPPS will then ask you to turn off the ignition key and wait for a few seconds. Click "OK" after switching off the key.
10) Switch on the key to continue. Lights on the dashboard will come off together and then go off one by one.
11) Turn on the key again.
12) Click on "Write (F3)" to start ECU remapping.
13) MPPS will ask you to switch off the key to continue in a few minutes.
14) Click "OK".
When you hear a "ding" sound, it means the ECU remapping is finished. Disconnect MPPS V16 from the car and unplug the cable.

ECU Chip tunning tool

No comments:

Post a Comment