Tips on how to Use a Fault Code Reader

A fault obd2 scanner assists you in repairing your automobile by telling you what the vehicle's self-diagnostic procedure "thinks" is incorrect. Given that 1996, Federal law necessitates that all cars offered within the United states of america be on-board diagnostic (OBD) compliant. The normal in 2011 is OBD2 and it is an improvement within the unique process. Whenever a fault code enters the vehicle's pc it triggers the test engine light. By understanding that code, you are able to promptly narrow down the problem and make your fix.
Turn the vehicle's ignition on the off place.
Locate the vehicle's 16-pin information hyperlink connector. This looks similar to a laptop serial port and it is ordinarily positioned beneath the dashboard below the steering wheel or within the left, bottom corner.
Push VDM UCANDAS the code reader's cable connector in to the vehicle's information link connector. Be cautious to adequately align the connections in order to avoid damaging the pins.
Look in the OBD2 code reader to determine if it automatically turned on if you plugged it in to the car. If it didn't you might possess a difficulty using a blown fuse. Verify your fuse panel and replace any blown fuses.
Turn the vehicle's ignition on the on place but don't begin the automobile. The fault code reader will immediately verify the vehicle's computer for fault codes.
Wait ten to 60 seconds for your fault code reader to download the codes. The codes is going to be displayed on the screen with an explanation of your dilemma. If there may be greater than a single code on the vehicle's computer, you'll be able to cycle as a result of them by pressing the button with an arrow pointing for the proper.
Record the fault codes CK-100 on the note pad for reference when operating on the motor vehicle.