Hyundai
remote key programming successfully! With Xhorse VVDI2 key programmer.
Tools
preparation:
Vvdi
tools (Xhorse VVDI2)
Here are the remote generation
steps...
Step 1 - chip information
collection via VVDI2
xhorse
Install
the battery for the new wirless remote key
-
take out the pcb on the remote controller
-
install the battery
Generate
wireless universal remote into chip signal collector via VVDI2 v1.2.2 software;
VVDI2 automatically detect the chip
Press
the remote control buttons and the LED will keep flashing (it means that: it’s coming into the collection
status)
Signal
acquisition is successful when the LED flashes rapidly
Information
collection is complete. Now, ready for decoding and chip copy.
Step 2 - chip decoding and copy
by vvdi2 v1.2.2
Put the chip with a battery
installed into the remote control
Put the original car key into
VVDI2 device for identification
Click on Start copy in VVDI2
interface
To collect information in the car
and put the collector into VVDI2 (because we have been collecting data, it’s ok to put the collector into vvdi2)
Put the original key into vvdi2
key programmer again
Connect to the network, to begin
decoding online
Chip decoding success!
Put the the the collector (vvdi remote key) into
vvdi2
Chip copy success
Step 3 - remote control
generation
Try to start the car with the new
copied key, after chip copy success
It can start the car but the
remote cannot work properly
Ready to generate remote control
Use vvdi2 control generating
function to generate the remote control
Put the new key into vvdi2
programmer
Finish vehicle info selection and
click on Generate Remote Control
Complete
Use special equipment) to program
the remote
Xhorse wireless universal remote
can copy a chip after regeneration as remote control, in the new equipment (will add this function)
Done!
No comments:
Post a Comment